sales@fectgroup.com    +86-335-8581678
Cont

Have any Questions?

+86-335-8581678

Nov 15, 2021

What is the manufacturing process of the bellows?

Various materials are used to form corrugated pipes. It is required to have good plasticity and welding performance. Smaller diameter corrugated pipes are usually made of seamless pipes, but small diameter stainless steel corrugated pipes for plumbing are manufactured by welding and polishing, which require softness and flexibility. The corrugated pipe with a diameter of more than 25mm can be formed into a corrugated pipe by longitudinal seam welding after forming a circular sheet or strip.


Additional consideration of materials The material used to manufacture the corrugated pipe, whether it is a pipe, a strip, or a plate, determines the thickness tolerance of the required material according to the performance requirements of the corrugated pipe. When rigidity is not the main performance requirement, the wall thickness tolerance can be +/-10% of the thickness. When the rigidity requirement is higher, the wall thickness tolerance is +/-5% of the thickness. The grain size of the corrugated pipe material before forming should be less than 35 um, and the unevenness of the grain should not be greater than level 2.


The materials used to make bellows mainly include stainless steel, tin bronze and beryllium bronze.


Austenitic stainless steel

Austenitic stainless steel (1Cr18Ni9Ti, OCr18Ni9, 00Cr17Ni14Mo2, etc.) has good mechanical properties and corrosion resistance. Bellows made with it are mostly used as isolation media or sealing elements.


Tin bronze

Tin bronze (QSn6.5-0.1, QSn6.5-0.4) has a certain degree of flexibility, good process performance, low hysteresis, high fatigue strength, good corrosion resistance, and is widely used in meters.


Beryllium Bronze

Beryllium bronze (QBe2) has good manufacturability, high elasticity and plasticity, low hysteresis, good corrosion resistance, high fatigue strength, and low elastic temperature coefficient. Bellows made with it are generally used on high-demand occasions.


Brass

Brass (H80) has good plasticity and process performance, but it has poor elasticity and large hysteresis. The bellows made of it are often used in conjunction with springs and are generally used on occasions where the requirements are not high.


In addition to the above-mentioned commonly used materials, there are constant elastic alloy Ni36CrTiAl (3J1), high-temperature alloy Inconel 718, and so on.


The inspection and acceptance of materials shall be carried out in accordance with relevant standards. The materials entering the factory must have quality certificates, and the use of materials must be accurate and traceable.


Send Inquiry